General InformationTripp Lite's SMX500RT1U intelligent, line interactive rack/tower UPS prevents data loss, downtime and equipment damage due to power outages, voltage fluctuations and transient surges. Requires only one rack space (1U) in a 2 or 4 post rack. Large internal batteries offer 17 minutes half load runtime and 5 minutes at full load. Maintains regulated 230V nominal output without using battery power during brownouts as low as 187V. 500VA/300 watt power handling capability. Includes a total of 7 IEC C13 outlets (6 UPS and 1 surge-only receptacle.) Supports simultaneous remote monitoring of UPS and site power conditions via built-in USB, DB9 monitoring ports, and SNMP accessory slot. Includes PowerAlert UPS monitoring and unattended shutdown software with complete cabling. Built-in accessory slot supports SNMP with optional SNMPWEBCARD adapter. Multi-function audible alarms and set of 5 front panel LEDs offer at-a-glance notification of UPS and line power status.Technical InformationPlug/Connector Type: IEC 320-C14Receptacles: 6 x IEC 60320 C13Dataline Protection: RJ-11Emergency Power OFF: YesTransfer Time: 4 msPower DescriptionLoad Capacity: 500 VA/300 WInput Voltage: 220 V ACOutput Voltage: 230 V ACManagementNetwork Management: SNMP ManageableInterfaces/PortsSerial Port: YesUSB: YesBattery InformationBackup/Run Time (Full Load): 5 MinuteBackup/Run Time (Half Load): 17 MinuteTypical Battery Recharge Time: 4 HourPhysical CharacteristicsHeight: 1.8"Width: 17.5"Depth: 11.8"Rack Height: 1UForm Factor: TowerWeight (Approximate): 18 lbMiscellaneousPackage Contents: SmartPro 500VA Rack-mountable TowerSMX500RT1U UPS System with mounting hardwareTwo 1.8m IEC320-C13 to C14 load jumper cablesCabling for USB & DB9 monitoring and EPO switchingPowerAlert unattended shutdown and UPS/Power monitoring softwareWarranty informationAdditional Information: Switches: Includes 2 front panel mounted push-button switches for system enable, self-test and alarm cancel functionsLow voltage transfer to battery power: 187V (resets to line power as line voltage increases to 195V or higher)High voltage transfer to battery power: 264V (resets to line power as line voltage decreases to 256 or lower)Cold Start: Yes, inverter can be "cold started" to enable temporary AC output during a power failureCertifications & Standards: CE EN62040 listed, RoHS-CompliantSoftware Included: PowerAlert UPS monitoring softwareWarrantyLimited Warranty: 2 Year

OUTPUT
Output Volt Amp Capacity (VA): 500
Output Watt Capacity (Watts): 300
Power Factor: 0.6
Nominal Output Voltage(s) Supported: 220V 230V 240V
Nominal Voltage Details: 230v nominal inverter output voltage
Frequency Compatibility: 50 / 60 Hz
Frequency Compatibility Details: Automatic frequency selection
Output Voltage Regulation (Line Mode): -8%, +15%
Output Voltage Regulation (Battery Mode): +/- 5%
Output Receptacles: (7) C13
Included Output Power Cables: Two 1.8m IEC320-C13 to C14 load jumper cables
UPS Output Receptacles (Surge Suppression Only): 6 UPS outlets, 1 surge-only outlet
Load Management Receptacles: One switchable single-outlet C13 load bank
Hot-Swap PDU options: PDUBHV10 (2U / 8 C13 outlets)
Output AC Waveform (AC Mode): Sine wave
Output AC Waveform (Battery Mode): PWM sine wave
Individually Controllable Load Banks: No INPUT
Rated input current (Maximum Load): 2.4A
Nominal Input Voltage(s) Supported: 230V AC
UPS Input Connection Type: C14 inlet
UPS Input Connection Description: C14 inlet accepts user-supplied AC power cord with country-specific plug
Input Circuit Breakers: 8A
Input Phase: Single-Phase BATTERY
Full Load Runtime (min.): 3.2 min. (300w)
Half Load Runtime (min.): 14.6 min. (150w)
DC System Voltage (VDC): 12
Battery Recharge Rate (Included Batteries): Less than 4 hours from 10% to 90% (typical, full load discharge)
Internal UPS Replacement Battery Cartridge: RBC62-1U
Battery Access: Battery access door
Battery Replacement Description: Hot-swappable, user replaceable batteries
Expandable Runtime: No VOLTAGE REGULATION
Voltage Regulation Description: Automatic voltage regulation (AVR) maintains line power operation with input voltage as low as 187
Undervoltage Correction: Input voltages between 187 and 215 are boosted by 14% USER INTERFACE, ALERTS AND CONTROLS
Switches: 2 Switches control off/on power status and alarm-cancel/self-test operation
Alarm Cancel Operation: Power-fail alarm can be silenced using alarm-cancel switch once silenced, alarm will re-sound to indicate low-battery status
Audible Alarm: Audible alarm indicates power-failure, overload and low-battery conditions
LED Indicators: 5 LEDs indicate line power, battery power, overload, voltage regulation and battery low/replace status SURGE / NOISE SUPPRESSION
UPS AC Suppression Joule Rating: 480
EMI / RFI AC Noise Suppression: Yes PHYSICAL
Included Mounting Accessory Description: Included mounting flanges support rackmount installation in 2 or 4 post racks
Primary Form Factor: Rackmount
UPS Power Module Dimensions (hwd, in.): 1.73 x 17.32 x 11.61
Rack Height (U Spaces): 1
Minimum Required Rack Depth (inches): 13.86
UPS Housing Material: Steel
Primary UPS Height (mm): 44
Primary UPS Width (mm): 440
Primary UPS Depth (mm): 295 COMMUNICATIONS
Communications Interface: USB (HID enabled) DB9 Serial EPO (emergency power off) Slot for SNMP/Web interface
Network Management Cards: SNMPWEBCARD TLNETCARD WEBCARDLX
Network Monitoring Port Description: Supports detailed monitoring of UPS and site power conditions
PowerAlert Software: For local monitoring via the UPSs built-in communication ports, download PowerAlert Local software at http://www.tripplite.com/poweralert
Communications Cable: USB and DB9 cabling included
WatchDog Compatibility: Supports Watchdog application, OS and hard-reboot restart options for remote applications
Network UPS Tools Compatibility: NUT compatible. See the full list of Tripp Lite NUT compatible UPS systems at networkupstools.org/stable-hcl LINE / BATTERY TRANSFER
Transfer Time: 2-4 milliseconds
Low Voltage Transfer to Battery Power (Setpoint): 187
High Voltage Transfer to Battery Power (Setpoint): 264 SPECIAL FEATURES
Grounding Lug: Back panel grounding lug
Cold Start (Startup in Battery Mode During a Power Failure): Cold-start operation supported
High Availability UPS Features: Hot swappable batteries
Green Energy-Saving Features: Greater than 95% efficiency - GREEN UPS Individually controllable load banks CERTIFICATIONS
UPS Certifications: Additional certifications CE ROHS (Restriction of Hazardous Substances) Tested to EAC (Belarus, Kazakhstan, Russia)
UPS Certification Details: LVD 2014/35/EU EMC 2014/30/EU EN 62040-1: 2008+A1: 2013 EN 62040-2: 2006+AC: 2006 Item Dimension (L"xW"xH")
5 x 16 x 22

Weight
20.8 lbs

Warranty Information
2-year limited warranty