Line-interactive, uninterruptible power supply (UPS) with enhanced LCD interface offers network-grade power protection for your critical server, network and telecommunications equipment. UPS with built-in, auto-voltage regulation (AVR) actively corrects brownouts and overvoltages back to usable levels while maintaining a full battery charge in case of a power failure. Interactive LCD interface reports UPS operating mode, detailed UPS and site-power data, plus enables a variety of UPS setup and configuration options. Super-fast switchover from line to battery power occurs within milliseconds to maintain operation of connected equipment without interruption. 95 percent line-mode efficiency offers reduced heat emissions and operating costs. USB and RS-232 ports work with PowerAlert software to communicate detailed UPS status and site power conditions. Communications ports enable detailed monitoring of equipment load levels, self-test data and utility power conditions.Tripp Lite UPS Smart 1000VA 700W Rackmount LCD Pure Sine Wave AVR USB 2URM
OUTPUT
Output Volt Amp Capacity (VA):1000
Output kVA Capacity (kVA):1.0
Output Watt Capacity (Watts):700
Power Factor:0.7
Nominal Output Voltage(s) Supported:120V
Frequency Compatibility:60 Hz Output Voltage Regulation (Line Mode):-21%, +8%
Output Voltage Regulation (Battery Mode):+/- 5%
Output Receptacles:(6) 5-15R
Output AC Waveform (AC Mode):Sine wave
Output AC Waveform (Battery Mode):Pure Sine wave INPUT
Rated input current (Maximum Load):9.2A
Nominal Input Voltage(s) Supported:120V AC
UPS Input Connection Type:5-15P
Input Circuit Breakers:10A
UPS Input Cord Length (ft.):10 UPS Input Cord Length (m):3
Recommended Electrical Service:15A 120V
Input Phase:Single-Phase BATTERY
Full Load Runtime (min.):6.4 min. (700w)
Half Load Runtime (min.):15.6 min. (350w)
DC System Voltage (VDC):24
Battery Recharge Rate (Included Batteries):Less than 4.5 hours from 10% to 90% (typical, full load discharge) Internal UPS Replacement Battery Cartridge:RBC24V-LCD
Battery Access:Front panel battery access door
Battery Replacement Description:Hot-swappable, user replaceable batteries
Expandable Runtime:No VOLTAGE REGULATION
Voltage Regulation Description:Automatic voltage regulation (AVR) maintains line power operation with an input voltage range of 83 to 147
Overvoltage Correction:Input voltages between 128 and 147 are reduced by 12%
Undervoltage Correction:Input voltages between 83 and 107 are boosted by 14% USER INTERFACE, ALERTS and CONTROLS
Front Panel LCD Display:
Front panel LCD information and configuration screen offers detailed UPS and site power status and operating data, plus configuration of voltage, operating mode, alarm function and a variety of additional options (see manual for detailed LCD configuration and monitoring options) Switches:
3 pushbutton switches control OFF / ON power status, MODE selection and MUTE / ENTER control functions Alarm Cancel Operation:
Power-fail alarm can be temporarily silenced using alarm-cancel switch silent mode alarm configuration option available Audible Alarm:
Audible alarm indicates UPS startup, power-failure, low-battery, overload, UPS fault and remote shutdown conditions SURGE / NOISE SUPPRESSION
UPS AC Suppression Joule Rating:570
UPS AC Suppression Response Time:Instantaneous
EMI / RFI AC Noise Suppression:Yes Included Mounting Accessory Description
Includes UPSHDEARKIT for 2 point front-mount and 2 point center-mount rackmount installation in 2 and 4 post racks, plus wallmount installation Installation Form Factors Supported with Optional Accessories
4 post rackmount (4POSTRAILKIT) Tower (2-9USTAND) Wallmount (2POSTRMKITWM) Primary Form Factor
Rackmount
Cooling Method
Fan
UPS Housing Material
Steel COMMUNICATIONS
Communications Interface:DB9 Serial EPO (emergency power off) USB
Network Monitoring Port Description:Supports detailed monitoring of UPS and site power conditions
PowerAlert Software:Available via free download from www.tripplite.com
Communications Cable:USB cabling included WatchDog Compatibility:
Supports Watchdog application, OS and hard-reboot restart options for remote applications
Network UPS Tools Compatibility:
NUT compatible. See the full list of Tripp Lite NUT compatible UPS systems at http://www.networkupstools.org/stable-hcl.htmlmanufacturerTripp Lite LINE / BATTERY TRANSFER
Transfer Time:4 milliseconds (AC to battery), 1 milliseconds (Battery to AC)
Low Voltage Transfer to Battery Power (Setpoint):83
High Voltage Transfer to Battery Power (Setpoint):147 SPECIAL FEATURES
Grounding Lug:Back panel grounding lug
Cold Start (Startup in Battery Mode During a Power Failure):Cold-start operation supported
High Availability UPS Features:Hot swappable batteries CERTIFICATIONS
UPS Certifications:Tested to UL1778 (USA) Tested to CSA (Canada) Tested to NOM (Mexico) Meets FCC Part 15 Category B (EMI)
© 2024 BrokerDen. All rights reserved.
